Microclimate Ministat 300

 MINISTAT 300 bulbs, heatmats etc. up to 300watts.

The ministat will operate any mains voltage heater as listed below :-

MINISTAT 100 heat mats up to 100 watts.

MINISTAT 300 bulbs, heatmats etc. up to 300watts.

Do not attempt to operate the ministat with a greater load than specified. To do so may result in damage to the ministat.

Connect the mains cable from your heater to the heater output of the ministat (fitted mains socket) using a suitable 13A plug (fitted with a 3A fuse).

Connect the ministat to the mains supply using the fitted mains plug.

Please note the mains plug is fitted with a 3A fuse which must be replaced with a 3a fuse in the event of a failure.

The mains cables fitted to the ministat are colour coded as follows :-

(Brown-Live) (Blue-Neutral) (Green/Yellow-Earth)

Position the ministat sensor in the vivarium approximately 225mm (9 inches) away from the heat source. This is to ensure the sensor is measuring air temperature and not direct heat.

Always use a thermometer to check the temperature of the vivarium and adjust the ministat as required to give the required temperature.

A small flat blade screwdriver can be used to adjust the temperature control of the ministat.

The ministat has a power indication led. When the led is lit power is being supplied to the heater.